MIMAKI JV3-160S Guia de Configuração descarregar pdf (Página 61)

– 3.23 –

3-4-8. Banding (wind repples)

Problems Banding (wind repples) occur at each scan.

Causes 1) The platen temperature setting is not appropriate. (too low.)

Checking procedures 1) Raise the print-heater temperature to see that no blotting or beading occurs.

2) Raise the print setting (pass) to see that no blotting or beading occurs.

(For some media, the problem of blotting or beading cannot be solved

completely.)

Remedies 1) Raise the print-heater temperature.

After change the temperature of heater, be sure to adjust [MEDIA

COMP.].

2) Change the print setting (pass) to high class.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 169 170

Sem comentários

MIMAKI JV3-160S Guia de Configuração Página 61