MIMAKI UJF-706 Especificações descarregar pdf (Página 116)

4-22

Slowly shake the white ink cartridge more than twenty times right

and left.

• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover

the A part of the upper surface of the cartridge and the B part of the bottom surface of the

cartridge with paper towels. Then, shake it more than twenty times right and left so that ink

flows inside the cartridge.

When the next screen is displayed, set

the white ink cartridge to the ink station

again.

• As shown in the drawing, set an ink cartridge

turning the IC chip side up.

• If you shake it too strong, the pack inside may be damaged and it may cause ink leakage.

Therefore, perform this carefully.

• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt the

cartridge until it becomes vertical.

Cover with paper towel

firmly and shake ink slowly

A part

(the place to stick a needle)

B part

(the slot on the bottom)

Repeat this

A part

WH I T E M A I N T E N A N C E

SET CARTR I DGE

IC chip

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 183 184

Sem comentários

MIMAKI UJF-706 Especificações Página 116