MIMAKI UJF-706 Especificações descarregar pdf (Página 47)

2-11

Basic Operations

Setting media

For this machine, you can use the media of 150 mm thickness or below.

For the media to be used, refer to P.1-16 "Usable media size".

Set the media.

Pressing the key, absorb the media to the table.

• In the inkjet printer, ink drops tend to turn into mist when the gap between head and media is set wider

than 2mm because of the insurmountable length. The more the gap get wider, the more likely it occurs.

The mist of ink adheres to the head surface and the filter of the cooling fan. Also, the reflection from the

UV light becomes higher. In case the adhered ink is cured or get sticky by the UV light reflection, it

causes nozzle clogging and mismatched ink position. Sometimes it may be necessary to replace the

head due to the failure.

• If, within the absorption area, there are suction holes not closed by the media, close such suction holes

placing thin sheet form material such as paper, film or tape.

• The peripheral parts of the media could roll up due to heat. Fix the media supplementarily using

adhesive tapes, etc.

After setting the media, set the followings.

• Register the head gap. ( P.3-16)

• Check the head gap. ( P.3-5)

VACUUM

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 183 184

Sem comentários

MIMAKI UJF-706 Especificações Página 47